Saniflo Sanipack In Wall Macerator
The SanifloStore is The Original Online Stocking Distributor for Saniflo SFA. We Know Saniflo! If you have questions about the Saniflo product line feel free to call us anytime.
Warranty: 5 Year on Cutting Blades, 3 Year on pump
Wall mounted toilet is not included, you are free to choose the model you would like which would then drain into this pump.
Sanipack is a macerator device which is meant to be installed inside a wall
cavity. The Sanipack is a system that is used to install a complete
bathroom up to 9 feet below the sewer line, or even up to 100 feet away from a
soil stack. It can handle the effluent from a toilet, sink and shower.
Sanipack is simplicity itself to install; there are just four connections.
- The macerator/pump is
connected to the discharge pipe coming from a wall hung toilet
- The toilet tank is
connected to the water supply
- The macerator/pump is
connected to the small diameter discharge pipe work
- The macerator/pump is
connected to the electrical supply
inside of the Sanipack is comprised of a pressure chamber, which starts and
stops the unit, and the motor, which drives the stainless steel macerator
blades and the pump.
the flush is activated, the water flowing into the Sanipack activates a micro
switch in the pressure chamber which in turn starts the motor. The motor
is sealed for life in an oil filled enclosure. A common spindle/shaft
drives the impeller and the macerator blades. The moving parts therefore
are kept to an absolute minimum. Water and organic waste matter enter the
chamber and are reduced to slurry as the macerator blades rotate at 3600 RPM.
The centrifugal force causes the reduced solids to be ejected through a
grill into the container where it is picked up by the impeller pump mounted
beneath the motor.
unit pumps the effluent upward to 9 feet and/or 100 feet horizontally (with
gravity fall). Once the water is discharged and the water level in the
container goes down, the micro switch deactivates the unit until the flush is
activated again. A normal operating cycle for Sanipack takes about 7-9
seconds depending upon the discharge pipe run configuration; power consumption
is therefore minimal.
In addition to the toilet waste, the Sanipack will also discharge gray water
from a variety of other sanitary fixtures such as: a sink, a shower and a
urinal. When adding a shower, a base will have to be constructed.
This base should be made out of a 2″ x 6″ (minimum) or 2” x 8”
(recommended) on edge, to allow for the installation of a P-trap and the
required 1/4”per foot gravity flow towards the pump unit.
The wastewater from other sanitary fixtures is discharged into the Sanipack via
two 1-1/2 inch inlets on either side of the housing. Either one or both
inlets can be used as required. The discharge elbow on top of the
Sanipack can be turned either to the left, to the right, or towards the back,
depending on the discharge installation. A non-return valve, which comes
already assembled on the discharge elbow, prevents back flow into the
unit has been designed with a vent connection on the lid. All plumbing
codes require connection to a vent system. Please note that the vent
system should be a two-way air vent. The use of mechanical vents, air
admittance valves or similar devices are not permitted as these are considered
one-way air vent systems.
also highly recommended for the macerator/pump to be connected to a Ground
Fault Interrupter (GFI) circuit.
Sanipack is designed to be used with a wall hung toilet. The depth of the
case allows for this pump to be installed within the wall. Since the
reservoir, the macerating pump and the pipes are hidden from view, this type of
installation gives you the lean and clean look of a European bathroom.
The Sanipack has been
certified to American and Canadian Standards. Macerating standard; US:
CSA Certified & IAPMO (UPC) listed – ASME A112.3.4, CA: Macerating Standard
- Items are usually shipped the same day if the
payment is made by 3pm EST
- We ship via Fed Ex and USPS. Tracking
information is always sent to your email address. Please check any spam
filters as it may end up there.
- If you need a package overnighted or expedited
let us know. Please notify us prior to payment so we can invoice
you for the additional charges.
- International buyers are responsible for all
tariffs, duties, taxes, fees and Vats. Customs forms will be completed in
accordance with US law.
- We can only ship to confirmed Paypal
- If paying by Paypal, please do not send payment
until your Paypal address is confirmed.
- You are more then welcome to save on shipping
and pick your items up at our facility during business hours M-F 9-4.
Please contact us for directions.
- We will combine shipping for multiple
- Large ticket items will ship with signature
- Items are described to the best of our ability,
if you have a question about an item please do not hesitate to ask.
- If you have a specific question on the use and
or installation of an item, please refer to the manufacturer’s website.
- If you have zero feedback, please contact us
before bidding on or buying an item.
- Please know exactly what you are buying. On
every listing we will include the manufacturer’s part number. Please do
whatever research you need to on the respective parts before purchasing.
- Please do not purchase something unless you
intend on paying for it.
- Please read all the policies, conditions,
additional terms of sale, etc. prior to bidding/buying.
- If an item is posted for an auction please do
not ask for a Buy It Now price.
- Please contact us in advance with any
questions, our (toll free) number is 866-658-0505
- Payment is expected within 5 days
of auction’s close or Buy It Now.
- Paypal is our preferred payment method.
- Credit Cards are accepted and must be
called in to our office between 10am – 4pm EST, Monday –
- Wire transfers are accepted,
please contact us for more information if you would like to pay
via wire transfer.
- Cash for pick ups at our location is OK,
but please have exact cash on hand.
- If an item is received by you as not working,
damaged from transit, not as described, etc. please contact us
- Returned items must be approved and must
accompany the Return Authorization Number (RMA#) we provide.
- If an item is defective a replacement will be
shipped when the defective item is received back to us.
- If a replacement is not available, a refund
will be granted when the defective item is received back to us.
Unauthorized returns, or
items returned for reasons other than defect, damage or inaccurate
description are subject to 15% restocking fee plus any shipping costs that we
incurred shipping the items to you